FAAC Gate Access Control Nationwide

FAAC Gate Access Control in Euless: What to Know First

FAAC gate access control repair in Euless typically runs $185 to $480 depending on whether we’re replacing a keypad, a receiver board, or rewiring a phone entry system, and most jobs are completed in a single visit. We’re an independent FAAC service provider, not a factory authorized dealer, which means we make repair decisions based on what’s actually wrong with your gate, not what the warranty department wants us to sell. If you own a FAAC gate opener in Euless and the keypad stopped responding, the remote won’t transmit, or the phone entry stopped ringing the house, call (806) 484-1837 and a live person will answer.

Call (806) 484-1837

This page is for homeowners in Euless who have a FAAC operator on the driveway and need the access control side of it working right: keypads, remotes, card readers, video intercoms, and phone entry. We’re gate specialists, not general electricians. Victor Salinas and our technicians have worked on FAAC equipment across the Mid-Cities for nearly three decades, and we know which FAAC model lines hold up and which ones need a specific part replaced rather than a whole board swap.

How FAAC Products Fail – and How We Fix Them

• FAAC 402 and 412 operator keypads losing one row of buttons. The 402 and 412 series are common on Euless residential driveways, and we regularly see the ribbon cable between the keypad face and the control board corrode at the connector. The symptom is predictable: numbers 1, 4, 7, and * work while the rest don’t, or the whole pad dies after a rain event. The fix is cleaning and reseating the connector or replacing the ribbon, not the entire keypad assembly. Some companies quote a full keypad replacement for this, which is unnecessary.
• FAAC 844 and 844ER slide gate receivers failing to pair with remotes after a power surge. The 844 line is a workhorse, but its receiver is sensitive to the voltage spikes we get in Euless during spring thunderstorms. When a lightning strike or downed line sends a surge through the house, the receiver’s memory can scramble, and remotes that worked for years suddenly stop transmitting. The fix is a factory reset and reprogram, or a receiver swap if the surge took the board. We always check the operator’s surge protection while we’re there because the next storm will do it again if there’s no suppressor on the line.
• FAAC S418 and S450 hydraulic operators with phone entry that rings but won’t open the gate. On these hydraulic models, the phone entry unit communicates with the opener through a dry contact relay on the control board. That relay fails before anything else, and the symptom is specific: the house phone rings when a visitor calls the gate, the visitor hears the operator click, but the gate never moves. The relay is a $15 part. We replace it in about forty minutes. You don’t need a new phone entry system or a new board.
• FAAC E045 and E124 control boards refusing to learn new remotes. These boards are used in a lot of Euless estate gates, and the symptom is always the same: an owner buys a new remote online, follows the pairing procedure, and the board won’t accept it. The cause is usually a compatibility mismatch between the remote’s frequency and the board’s receiver revision, not a fault in the board itself. We carry the correct OEM remotes for each board revision and match them on site. It saves the owner the frustration of buying a second wrong remote from an online marketplace.
• Video intercom systems wired into FAAC operators showing a black screen at the house monitor. This one is specific to Euless homes with older video intercom wiring run through the same conduit as the gate’s low-voltage control lines. Over twenty or thirty years, the insulation on that wiring dries out in the Texas heat, and the video signal degrades until the monitor shows nothing. The operator still works, but the homeowner can’t see who’s at the gate. We re-pull the video pair or install a wireless video adapter, depending on the conduit. Most Euless homes built before the early 2000s need the re-pull.

Our FAAC Gate Access Control Process

1. 1
   You call, a person answers. No menu, no queue. We ask what the gate is doing or not doing, what model you have if you know it, and when you need us there. We schedule a window we keep.
2. 2
   We show up and diagnose the exact fault. Our technician tests the keypad, receiver, wiring, and control board in that order. On a FAAC job, we’re looking specifically at the ribbon connectors, the dry contact relay, and the receiver revision, because those are the known weak points on this brand.
3. 3
   We give you the price before touching a tool. The cost is agreed in writing before any work starts. If the fix is a ol5 relay, that’s what you pay for. If it’s a full board, we show you why and we don’t pad the invoice with parts your gate doesn’t need.
4. 4
   We use OEM parts where the warranty still matters and quality aftermarket where it doesn’t. FAAC warranties vary by part and age. For a receiver or control board on a newer unit, we use OEM to keep the coverage intact. For a keypad ribbon or a relay on a twenty-year-old operator, an aftermarket part often matches or beats the original at a better price, and we’ll tell you which we’re using and why.
5. 5
   We test the whole system, not just the part we touched. Every remote, every keypad code, the phone entry, the safety edges, and the auto-close timer get cycled before we leave. A FAAC gate access system that opens but doesn’t auto-close is still broken.
6. 6
   We walk you through what we did and hand you the written guarantee. Every job gets our 90-Day Done Right Promise. If it’s not right, we come back and make it right. No paperwork, no arguing.

What FAAC Gate Access Control Costs in Euless

Here’s what we charge for the most common FAAC access control jobs in Euless. These are real ranges, not bait numbers.

• Keypad replacement (FAAC 402, 412, or aftermarket compatible): $185 to $310 installed
• Receiver board swap (FAAC 844, 844ER, or E045): $240 to $410 installed
• Dry contact relay repair on phone entry systems: $90 to $160
• Full phone entry or video intercom replacement wired into a FAAC operator: $420 to $780 installed
• Remote programming and pairing (up to 3 remotes): $75 to $140

What moves the price: the age of the operator, whether we’re working at the gate or at the house side, and whether the wiring needs to be re-pulled. Every estimate is free, and the price you’re quoted is the price you pay, agreed before the first bolt is turned. Call (806) 484-1837 and we’ll give you a number over the phone.

Why Euless Homeowners Call Ironworks Gate Co. for FAAC Work

We’ve been serving Euless and the Mid-Cities for over 42 years, and we got here by fixing the gate the first time and standing behind the work. Every FAAC job we do carries the 90-Day Done Right Promise in writing, no fine print, no phone tag. A live person answers our phone 24 hours a day, 7 days a week, because a gate that won’t close at 9 p.m. is not a Monday morning problem. Our technicians are background-checked, uniformed, and trained on nine opener brands, so if you ever decide to switch from FAAC to LiftMaster, Mighty Mule, Ghost Controls, or DoorKing, we handle that too without missing a step. The company that makes a 40-year-old gate close like the day it was hung knows what it’s doing. That’s us.

FAQs