Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Colleyville
Gate access control in Colleyville means keypads, remotes, phone entry, and video intercoms that let you open your driveway gate without leaving the car. For most Colleyville homes, a new keypad or video intercom runs between $400 and $2,800 installed, depending on the gate operator you already have and whether we’re adding new wiring or tying into existing Viking, Apollo, or LiftMaster logic. That’s the honest range, and we quote it before any work starts.
We know Colleyville gates differently than a general electrician or handyman would. The homes off Cheek-Sparger Road, Pleasant Run Road, and John McCain Road were built in a specific era, with specific heavy ornamental gates, and the access systems on them don’t fail randomly. They fail in patterns. Call us at (806) 484-1837 and a live person answers, 24 hours a day, seven days a week.
Why Ironworks Gate Co. Is Colleyville’s Preferred Gate Access Control Company
We’ve been doing this work since 1984, and Victor Salinas has built Ironworks Gate Co. around a simple rule: a gate that worked for twenty years should work for twenty more. Colleyville homeowners call us because their gate is heavy, ornamental, and was put in when the house went up in the 1990s or early 2000s, and the operator that came with it is now at the end of its service life. We don’t upsell, and we don’t replace parts that don’t need replacing.
Every technician who comes to a Colleyville property is background-checked, uniformed, and trained on nine automation brands, including LiftMaster, FAAC, and Viking. That matters when your circle-drive gate has an Apollo control board and a keypad that stopped talking to it after a storm. Most jobs are completed in one visit. And every job carries our 90-Day Done Right Promise in writing. If it’s not right, we come back and make it right. No paperwork, no arguing.
Our Gate Access Control team coordinates scheduling and dispatch from the Dallas-Fort Worth office, so a Colleyville call gets a Colleyville crew. We know the neighborhoods, the gate styles, and the failure patterns. That’s the difference between a repair that lasts and one that doesn’t.
Our Gate Access Control Services in Colleyville
Keypad Entry
A keypad on the gate post or a wireless unit mounted at the driveway lets family, guests, and delivery drivers punch in a code instead of fishing for a remote. In Colleyville, most keypads we install are tied into an existing Viking or Apollo receiver on the operator, and a typical installation runs $400 to $950 for a quality exterior-rated unit. We set it, program custom codes for the household, and test it against the gate’s full swing arc before we leave.
Remote Control
The original remotes that came with a 1998-era gate operator are usually lost, broken, or running on a frequency that newer garage door openers interfere with. We program new remotes, replace receivers, and can wire a modern receiver into an older Viking or FAAC board without replacing the whole operator. For Colleyville homes with double gates, we program both arms to one remote so a single button opens the full driveway.
Phone Entry
Phone entry puts a caller box at the gate. A visitor dials a code or rings the house, and you answer from your cell phone or a small in-home console and buzz them in. This is common on Colleyville’s estate properties where the gate sits a hundred feet from the front door or more. Installation typically runs $900 to $2,000 depending on whether we’re pulling new low-voltage wire or using a cellular unit that needs no landline.
Card Reader
Card readers on Colleyville gates show up where families want a permanent credential for a nanny, landscaper, housekeeper, or pool service without handing out keypad codes that can be shared. We install proximity readers that work with a fob or card and tie directly into the operator’s open-input. A single-reader installation runs $500 to $1,100, and we can add multiple readers for estates with a service gate off the back drive.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Colleyville
Most Colleyville gates built in the 1990s and early 2000s carry Viking, Apollo, or Elite operators. The newer systems in this area run LiftMaster, FAAC, BFT, and Mighty Mule. Our techs are trained and equipped on all nine major brands, so when a dual-swing gate off Glade Road loses calibration or a slide gate on a Montclair Drive property starts chattering, the correct fix happens on the first visit. We stock common control boards, DC motor brushes, and safety edge components locally for Colleyville jobs, which keeps turnaround short.
Common Gate Access Control Problems We See in Colleyville Homes
Colleyville’s gate failures follow a pattern. Here’s what we see most often, and why it happens here more than in neighboring cities:
- Dual-swing gates drifting out of sync: Viking and Apollo boards lose their dual-operator calibration after a power surge or a dead battery in one arm. The master leaf lags a second or two behind, and you get a three-inch gap at the latch point on a circle driveway. This is the single most common service call in the 76034 ZIP code right now.
- Clay soil moving the hinge post: Colleyville sits on expansive black Vertisol clay that heaves in wet winters and contracts in triple-digit summers. A post shifts a quarter inch, the gate binds or drags, and the operator overcurrents until the motor burns out. We see this every summer.
- Heat-degraded control boards and motor brushes: DFW heat above 100°F kills DC motor brushes and board capacitors faster than manufacturer service intervals predict. The symptom is usually intermittent ghost reversing where the gate stops and reverses mid-cycle for no obvious reason. On LiftMaster and FAAC operators in Colleyville, this shows up year eight or nine, not year twelve.
- Keypads and intercoms failing after storms: A power surge on the Colleyville grid takes out keypad memory or the phone-entry relay on older Viking receivers, leaving the gate dead to the keypad but fine from the remote. We replace the surge-damaged board, reprogram the codes, and add surge suppression where the operator’s power feed doesn’t have it.
We recently spent a morning at a circle-drive estate off John McCain Road, where both Viking operators on a dual-swing gate had drifted so far out of sync the master arm lagged a full two seconds behind the slave. The hinge post on the heavy ornamental leaf had also rotated out of plumb by an inch from clay heave, binding the gate against its arc of travel. We pulled the Viking control board, re-synchronized the dual-operator logic, added an external wireless keypad and video intercom tied into the same Viking receiver, and reset the post in a new 42-inch concrete footing before re-hanging both leaves. The gate now cycles silent and locks square every time.
Pricing for Gate Access Control in Colleyville, TX
Here are the real numbers for Colleyville’s market, based on what we quote most weeks in this ZIP code:
- Keypad entry installation: $400 - $950
- Video intercom installation: $800 - $2,800
- Phone entry system: $900 - $2,000
- Card reader (single entrance): $500 - $1,100
- Remote programming or receiver replacement: $150 - $450
- Full access control retrofit on a dual-swing gate: $1,800 - $3,500
The final number depends on the operator’s age and brand, whether existing low-voltage wire is sound, and how many entrances you’re securing. The price is written, quoted, and agreed before a single bolt turns. Standing offers apply: $50 off any repair over $250, a free second opinion on any written estimate, and a 5% senior and veteran discount. Call (806) 484-1837 for a free estimate.
We Also Serve Cities Near Colleyville
Our crews cover Colleyville and the surrounding communities including Bedford, Euless, Southlake, and Hurst. If your property sits closer to the Bedford line or out toward Southlake’s west side, the same Gate Access Control in Colleyville team handles it. Scheduling and dispatch stay local, and the written quote holds wherever in 76034 or the neighboring ZIP codes the gate sits.
Serving Colleyville, TX - Our Local Coverage Area
We’re based in the Colleyville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Colleyville
Because Colleyville’s 1990s estate boom put a huge number of dual-swing gates on circle driveways running Viking and Apollo operators, and those boards lose their calibration after a power surge or a dead battery in one arm. The fix is re-synchronizing the dual-operator logic and replacing the failing battery, which takes about an hour on most systems. Call (806) 484-1837 and we’ll get it sorted.
Yes. We wire modern keypads and video intercoms into Viking and Apollo open-input terminals and receivers all the time. The new device sends the same open signal the old one did, so the operator doesn’t know the difference. The only catch is if the old board’s relay contacts have burned, and then we replace the board rather than the whole operator. Estimates are free.
The black clay under Colleyville expands and contracts with moisture, so a wet winter lifts the hinge post and a dry summer drops it back. Either way, the gate leaf moves out of plumb and drags against its travel arc. The fix is resetting the post in a deeper concrete footing, not grinding the gate leaf to clear the ground. Grinding is a temporary patch that makes the gate look right for a season and fail again next year.
Automatic gates in Colleyville must have working entrapment protection, either safety photocells across the gate opening or a reversing edge that stops and reverses the gate if it contacts something. To test it, place a solid object like a trash can in the gate’s path and run a cycle. If the gate doesn’t stop or reverse, stop using it and call us. A gate that doesn’t reverse can injure a child or pet. We test every Colleyville gate’s safety loop as part of any access control job, and the $89 seasonal tune-up includes the full cycle test.
Usually the rack and pinion on a Colleyville slide gate has come out of alignment or the carriage wheels have worn, and the gate’s weight is no longer riding level. On heavy ornamental slide gates, the chatter is metal grinding against metal, and it gets worse until the operator’s overload sensor shuts the gate down entirely. The repair is alignment and wheel or bearing replacement, which we complete in one visit on most Colleyville properties.
Call Ironworks Gate Co. for Gate Access Control in Colleyville
The gate at the end of your driveway is the first thing anyone sees and the first thing that should work. If your keypad stopped responding after a storm, your dual-swing gates are fighting each other, or you want to add video intercom to a twenty-year-old Viking operator, we can do it right. Call (806) 484-1837 now. A live person answers, 24 hours a day, seven days a week. The quote is free, the price is set before any work begins, and the 90-Day Done Right Promise covers every job in writing.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Colleyville and the surrounding DFW communities with gate repair, installation, and access control since 1984.